Rice-lake Go-Between, Data Capture and Storage Manuale Utente Scaricare il pdf (Pagina 2)

2 Go-Between Installation and Operation

Transferring Data to PC (Industrial Enclosure)

Data on the Go-Between device is stored in a.txt file. To transfer data to your PC:

1. On the Go-Between, press

Close File.

2. Disconnect the flash drive from the Go-Betwe

en’s USB port.

3. Connect the flash drive to the PC’s USB port.

4. Navigate to the flash drive and open the .txt file to view its

contents. It can also be imported into Microsoft

Excel or other spreadsheet software.

POWER

TXD

RXD

FULL

LOST

SAVED

INSERT

READY

Notes

• When reset switch is in the OFF position and power is connected, only LED #1 will be ON.

• When reset switch is turned from

OFF to ON, all LED’s will be on for several seconds. This is a test mode to

let you know that all LEDs are working.

• When receiving DATA, #4 and #5 LEDs will light

for a short period of time.

• When #8 LED is on, you can remove the USB drive.

• If you want to remove the USB drive before #8 LED lights, press the

Close File button and wait for the #8

LED to be

ON before removing the USB drive.

Power Source Coming From Indicator

For devices that have the power source coming directly from the indicator use Table 1 and Figure 1.

Table 1. Go-Between Serial Wiring with Power Coming From the Indicator

Serial Output from Source Coming From Indicator Go-Between Input

TXD RXD

GND GND

+5VDC +5VDC

Figure 1. Wiring When Power Source is Coming From the Indicator

Note

Note the jumper position on the Go Between CPU board.

1 2 3 4

Nessun commento

Rice-lake Go-Between, Data Capture and Storage Manuale Utente Pagina 2